Maxx Tooling News and Updates

MaxxMacro Performance Pallets with Stop Pin (Fool Proofing)

02 / March , 2021

This variation of the MaxxMacro 54 Performance Pallet 54MM With .250 Dowels include a stop pin installed and matched to our MaxxMacro 70 Pneumatic 6001030 Pneumatic Chuck with Stop pin.

Posted in Informative, MaxxMacro, MaxxMacro Pallet, System 3R Pallet

MaxxMacro Premium Pallets. How do they look after 2800 cycles?

28 / October , 2020

Test Cycled one Maxx Tooling 50mm holder 2,844 times capturing offset data every 6th tool change..In general any visual wear was very minimal and unmeasurable

Posted in Informative, MaxxMacro

Custom MaxxMacro Tooling Delivered during Covid-19

25 / August , 2020

We can't always show the custom tooling we build, but this medical customer was kind enough to send us a nice bit of feedback and a photo.

Posted in edm tooling, MaxxMacro, Success, system 3r

Custom FCS® Compatible Self Centering Vise 4.725 Inch

22 / April , 2020

Produced for Prestige Extreme Distribution's customer on short order during the Covid-19 pandemic. Produced with custom pattern combined with typical FCS mounting pattern, allowing customer to...

Posted in Custom, Maxx-ER, MaxxMacro, self centering vise

New Custom Lang Compatible Vice 4.725 Inch Capacity

20 / April , 2020

One of Maxx Tooling's long time customers asked if we could configure our self centering vice to function in in current setup. We produced our vice with stop button to function on customer Robod...

Posted in Custom, lang self centering vise, lang vise, Maxx-ER, MaxxMacro, self centering vise

Hirschmann Stainless U30 Custom Holders

01 / November , 2019

Maxx Tooling produced these stainless Hirschmann U30 custom holders as a replacement to the customers current OEM aluminum holders they were using.

Posted in Custom, Hirschmann

Hot Deals